158ton 160ton Servo Motor Techmation Plastic Injection Molding Machine

158Ton 160Ton Servo Motor Techmation Plastic Injection Molding Machine

Contact Person: Andy Chou  

1) machines configuration
a) control: Techmation  ------------------------ Taiwan
b) servo motor:  Phase  ----------------------------Italy
c) Servo driver: Inovance---------------------------China
d) Pump: Sunny --------------------USA
e) Electron Components: Schneider--------------France
f) Position Transducer : Novotechnik----------------Germany
2) machines delivery times.

HRL158: We have stock, just as follows, the delivery time is 10 days.

3) payment item:
    30% down payment as T/T. rest 70% will paid by T/T before shipment.

Part two Machines warranty
1) all the machines will be given service for whole life.
2) all the machines warranty is 1 years. Except the easy broken parts. But all the casting parts with tie-bar will be 2 years
3) Screw warranty : if use 100% new material. will be one years. if 100% recyle material. Will be 6 month.
4) technology support for machines whole life.


Part three  machines setup and training customer's engineer
In usual our engineer can come to customer's factory setup and training engineer within 10days. engineer salary and visa payment paid by our side.  the air ticket (go and back) and your local hotel and safe also food paid by your side.

Part four Parameter of the HRL158

Screw Diameter: A: 38mm B: 42mm C: 45mm
Screw L/D Ratio: A: 23  B: 20.8  C: 19.4
Shot Volume (Theoretical): A: 260CM3  B: 318CM3  C: 365CM3
Injection Weight (PS): A: 230g B: 281g C: 322g
Injection Pressure: A: 223MPa B: 182MPa C: 159MPa
Max. Injetion Rate: A: 112CM3/S B: 137CM3/S C: 157CM3/S
Max. Plasticizing Capacity: A: 13.5g/s B: 16g/s C: 21.5g/s
Max. Screw Rotation: 208RPM
Injection Stroke: 230mm
Clamping Force: 1580KN
Toggle Stroke: 380mm
Min. Mold Height: 160mm
Max. Mold Height: 470mm
Space Between Tie Bars: 450*420mm
Ejector Tonnage: 53KN
Ejector Stroke: 120mm
Heating Power: 8KW
Heating Section: 3+1
Motor Power: 13KW
Oil Tank Capacity: 270L
Machine Dimension: 4.5*1.4*1.9m
Max. Pump Pressure: 16MPa
Machine Weight: 4Ton

Please take more reference for our machine for the following photos,








 

Working Principle

The grinding Process of the Main Mill is that the transmission device brings along the Central Shaft to drive. The upper part of the shaft connects with the Quincunx Rack, on the frame is loaded with the roller assembly, and forms a swinging pivot. The central shaft does revolve around the central rotation, at the same time it revolves around the grinding rings, and it self also rotates on account of the grinding effect. The shovel system, in the lower part of rollers, is loaded on the lower part of the Quincunx Rack. In the process of rotating of the shovel and the roller, the material will be fed gasket layer between the rollers and ring. The outside centrifugal force (compression force) yielding in this process will process the material into small powder, thus the desired powder is obtained.

Carbon Black Refinery Machine

Carbon Black Refinery Machine,Black Oil Refinery Machine,Base Oil Refinery Machinery,Waste Engine Oil Refinery Machine

Henan Lanning Technology Co., Ltd , http://www.lanningrecycling.com