![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
What is the mixer truck?
A: The mixer tug is a bearing. Use this to support the tank. It is integrated with the mixer and aids in mixing.
Second, how to change the hydraulic pump mixer truck?
A: Generally do not recommend that you change, directly to the sale to find professional personnel replacement, and the use of oil must meet the requirements, otherwise the equipment will be greatly damaged, the service life will be greatly shortened, replace the reasonable number of hydraulic oil.
3. What is the relationship between the filling rate of the cement mixer tank and the inclination of the tank?
A: At present, the tilt angle of the mixer is about 12 degrees, and the filling rate is about 63%. Poor inclination is difficult to measure and filling rate is also difficult to calculate. At present, the sales mixers are based on the effective mixing volume.
Fourth, the concrete mixer tank does not turn, turned to no power and hydraulic oil spray from the tank fuel port is what reason?
A: The hydraulic pressure will go back one by one. The failure of the hydraulic pump may be caused by the closed part of the oil pump. Back to the oil rush, it may be that the closed pad of the pump is broken. Look for another pad.
Fifth, how much is the speed of the mixing bucket of a concrete mixer?
Answer: The speed of the mixing drum when feeding: 6-10 rpm; the speed of the mixing drum when mixing: 6-10 rpm.
What is the distance from the inlet of the concrete mixer to the ground of the 8-12 square concrete mixer?
A: Generally, the height of the 8-12 square mixer truck is about 3.8 meters, and the feed inlet is about 3.5-meters from the ground, depending on different models.
Seven, cement mixer how to clean the tank? .
Answer: The water tank of the mixer truck should be filled with water after each unloading. When it is returned, it should be stirred and exercised. After the mixing station, the water will be discharged again. The tank's internal surface should be cleaned as it fills the tank. Of course, it can also be washed directly in the water tank. If the grout has already solidified, find a professional clear tank in the tank, the surface solidified with oxalic acid scrub on the line.
Precautions for daily maintenance of hydraulic cylinders
1. Regularly inspect the sealing components of the hydraulic cylinder, such as O-rings and gaskets, to ensure that they are intact and undamaged. If there is wear or aging, they should be replaced in a timely manner.
2. Regularly check the liquid level of the hydraulic cylinder and keep it within the specified range. If the liquid level is too low, add hydraulic oil in a timely manner.
3. Regularly inspect the connection parts of the hydraulic cylinder, such as oil pipes and joints, to ensure their tightness and reliability. If there is any looseness, it should be tightened in a timely manner.
4. Regularly clean the outer surface of the hydraulic cylinder to prevent dust, sand, and other debris from entering the interior of the cylinder and affecting its normal operation.
5. Regularly inspect the surface of the piston rod of the hydraulic cylinder, and promptly repair or replace it if there are scratches or wear.
6. Regularly inspect the hydraulic system of the hydraulic cylinder, and promptly handle any problems such as oil leakage or unstable pressure.
7. When the hydraulic cylinder is not in use for a long time, its hydraulic oil should be drained to avoid oil aging, deterioration, and affecting the normal operation of the hydraulic system.
8. When repairing or replacing hydraulic cylinders, attention should be paid to safety to avoid sudden movement or pressure release of the hydraulic cylinder, which may cause personal injury or equipment damage.
For Liugong Cylinder Seal Kit,For Liugong Swing Motor Seal Kit,Center Joint Seal Kit For Liugong,Center Joint Seal Kit Liugong
Safe Seal Technology Co., Ltd. , https://www.jolseals.com