Sharing of installation and use experience of high voltage static generator

Since its birth, the high-voltage electrostatic generator has been widely used in industries such as bicycles, automobiles, motorcycles, home appliances, hardware products, and wood furniture. It has good spraying quality, electrostatic coating particles, good adsorption capacity, and rough workpieces. The paint can be painted evenly on the surface and in the dead corner, which solves the problems of uneven thickness and color difference of the hand spray paint, and the quality is more stable. The excellent adsorption characteristics of static electricity make the coating rate reach more than 95%, which saves 30%-50% of the paint compared with the general hand spray, and the production cost is greatly reduced. The electrostatic spraying time is short, the coating is uniform, and it can reach 50-100um in a few seconds. The thickness of the coating fully meets the production requirements of customers, and the efficiency of the assembly line lifting system is increased several times, while saving human resources. The electrostatic system has the functions of over-current and short-circuit protection. The discharge to the ground "does not catch fire", it directly touches the ground or the workpiece is too close, the worker accidentally touches the automatic shutdown system, and the safety factor is high. It has been verified by multiple manufacturers and customers to have excellent performance with stable performance and long service life.

About the installation and use of equipment:

1. Fix the high-voltage static generator in place.

2. Install and fix according to actual work needs.

3. Connect a separate ground wire to the grounding post on the back of the instrument.

4. Insert the high-voltage plug into the output jack of the DC high-voltage supply (two holes, choose one of them), and lock it with the lock nut provided with the plug.

5. After confirming that the operating voltage of the power supply (commercial power) is consistent with the DC high-voltage power supply, insert the power plug of the high-voltage power supply into the grounded power supply socket.

6. Turn the power switch to the ON position, the switch indicator lights.

7. Turn the band switch to the "1" position (or 2, 3, and 4 positions are also possible), the red indicator light is on, the output voltage shows "0", and the DC high-voltage supply enters the standby state.

8. Direct control on the panel: press the STARTUP button and hold it for about 3 seconds. When the start is triggered, the red indicator goes off, the green indicator lights, the high-voltage output reaches and exceeds the undervoltage value, the high-voltage static generator enters a self-locking state, and the start button can be released. If you want to quit work (stop high-voltage output), just turn the power switch to the "OFF" position.